75 south street, hopkinton, ma 01748 ? 800-982-5737 ? 508-435-6831 ? fax 508 435-5289 ? www.valpeyfisher.com specifications: 4 0.01 10k 2 vcc features ? very small size (< 1.5 cm 3 , 4g weight) ? very low power consumption (<150 mw) ? very fast warm-up time (20s) ? high frequency range (80 mhz to 160 mhz) ? high stability (up to 1x10 -9 per c) ? low aging (2x10 -9 /day, 2x10 -7 /year @100 mhz) ? very low phase noise (-150 dbc/hz typ floor) dut output 50 ohm ?0.500(12,7mm) ?0.018 (0,45mm) 0.600(14,3mm)sq. 0.500 (12,7mm) 0.25 (6,35mm) min 0.500 (12,7mm) 0.345 (8,76mm) 12 3 4 0.49 (12,4mm)max vfth series miniature high frequency ocxo vfth series miniature high frequency ocxo 3 1 applications ? telecommunications, stratum-3 ? data communications, networking ? microwave sources ? battery powered systems and equipment ? gps ? instrumentation
75 south street, hopkinton, ma 01748 ? 800-982-5737 ? 508-435-6831 ? fax 508 435-5289 ? www.valpeyfisher.com parameter symb condition min typ max unit note absolute maximum ratings input break down voltage vcc -0.5 13.0 v storage temper. ts -40 85 c control voltage vc -1 9 v electrical frequency f 50 100.000 160 mhz all parameters for 100 mhz frequency stability f/f vs. temp. 150 500 ppb see chart below vs. supply 10 25 ppb/v aging per day per year 2e-9 2e-7 after 30 days allan variance .1s to 10s 1e-10 ssb phase noise 10 hz 100 hz 10 khz -100 -130 -155 -150 dbc/hz retrace after 30 minutes 50 ppb g-sensitivity worst direction 2.0 ppb/g input voltage vcc 8 10 12.6 v 5v under development input current icc steady state, 25c steady state, -30c start-up current 15 50 200 25 ma 10v supply load 50 ohm warm-up time to 1 ppm accuracy 25 s output waveform (+7 3) dbm sinewave 10 v supply control voltage vc 0 8 v pull range from nominal f 1.0 2 ppm deviation slope monotonic, positive 0.5 ppm/v setability vc0 @25c, fnom. 2.0 4.0 6.0 v 1 ppm preset clock avail. environmental an d mechanical operating temp. range -30c to 70c standard, other options ? see chart below mechanical shock per mil-std-202, 30g, 11ms vibration per mil-std-202, 5g to 2000 hz soldering conditions leads temperature 260c, for 10s, max hermetic seal leak rate less than 1x10 -8 atm.ccm/s of helium (crystal only) electrical connections pin out pin #1 ? vc; pin #2 ? gnd, case; pi n #3 ? output; pin #4 - vcc create a part number v fth frequency , mhz temperature range code specification a 0c to 50c b -10c to 60c c 0c to 70c d -20c to 70c e -30c to 70c f -40c to 85c temperature stability code specification 17 1x10 - 7 57 5x10 - 7 16 1x10 - 6 26 2x10 - 6 yz yx10 - z aging code specification l 2x10 - 9 /day s 5x10 - 9 /day supply voltage code specification 5 5v 5% * 0 10v 10% * - under development not all combinations are available. consult factory. ?v? for vcxo 12/08
|
